Vendor Links

 

Jeep Cherokee Blog

Feb 3, 2007

Install - Day 1


Today I installed the control arms and the trackbar. I also removed the transfer case drop.
Category: General
Posted by: andy
Well I got up early today and washed the jeep and drove around getting some stuff I needed to start my install. I called up my boddy and started removing the transfer case drop. My buddy arrived an hour later and I had the drop removed and was just aligning the bolts up to tighten them down to complete the job.
I had already squirted all the bolts with PB Blaster and so I assumed they would be good to go. We removed the left side control arm with little to no problem and put the new ones in without a snag.
We then started to remove the trackbar. I removed the bracket the trackbar ball joint was attached to so I could access the ball joint bolt on the other side. At the same time my buddy was working on the bolt that holds the other end onto the frame. He had it moving really slowly and it was banging then finally the bolt just busted in half. luckily it busted in a spot that wasnt too hard to finish taking it apart. After

Add A Comment


This is a captcha-picture. It is used to prevent mass-access by robots. (see: www.captcha.net)
Code in the picture:
Your Name(*):
Email:
Comment(*):
 
    Be the first to leave a comment!