Vendor Links

 

Jeep Cherokee Blog

Jan 20, 2007

SYE


I just finished installing my slip yoke eliminator.
Category: Modifications
Posted by: andy
I bought the SYE last week from Performance Off Road Center (PORC) and it arrived quickly. I installed it and everything went very smoothly. I had previously bought a double cardan driveshaft from ebay to replace the stock driveshaft. It is the exact same dimensions as the front driveshaft of my Cherokee. It is 28 inches from u-joint center to u-joint center when compressed and 31 when extended. Installed it has about an inch of extension left and 2 inches that it can be compressed.
I am very happy about how easy and how well the whole thing came together. Next step is to remove the two inch budget boost, remove the transfer case drop and install the RE 3.5 inch Super-Flex lift.

Add A Comment


This is a captcha-picture. It is used to prevent mass-access by robots. (see: www.captcha.net)
Code in the picture:
Your Name(*):
Email:
Comment(*):
 
  • December 13, 2012, 8:37 am - I love your how to's! I'll be installing the RE6030 as well and fully intend to use your guide. I wish you had a how to for the SYE, that into, intimidates me.
    So do you recommend getting a junk yard front drive shaft instead of an aftermarket one? Also, why did you raise up your TC?
    please email me back - Matt