Vendor Links

 

Jeep Cherokee Blog

Jul 2, 2007

Ready to install


Well I think I am ready to install my new Yukon 4.10 gears.

Category: Modifications
Posted by: andy

I am going to use Gear_Setup for my reference to install the front and back gears. I have my dial indicator finally and am ready. I hope it is easier than it looks to install these. I have done it before on my Ford Ranger rear differential but it was just a replacement so there wasn't as much to worry about like shims. I think I am going to get started today. I will document everthing that I do so future friends can benefit from my experience.

Add A Comment


This is a captcha-picture. It is used to prevent mass-access by robots. (see: www.captcha.net)
Code in the picture:
Your Name(*):
Email:
Comment(*):
 
    Be the first to leave a comment!